Do you nail shingles?

Because the thickness, weight, and shape of shingles vary, manufacturer’s instructions vary slightly. But virtually all manufacturers agree that nails should be installed below the adhesive strip. To keep a warranty intact, follow the manufacturer’s nailing and installation instructions closely.

Should shingles be stapled or nailed?

Fasteners for asphalt shingles should be roofing nails or staples. The head of a roofing nail or the crown of a staple is what actually holds a shingle in place. … If staples are properly installed, they offer nearly the same wind resistance as nails.

Are roof shingles glued or nailed?

Each shingle should be held by four nails. Six nails are preferred for areas that experience wind. The Home Depot has all the materials you need to in install roof shingles like a pro.

Can you nail through shingles?

A roofing system is designed to keep water out of your home. … If you drive even one nail into the top of your roof, you may compromise its entire system. That one nail will puncture the shingles and underlayment of your roof, creating a hole through the whole system.

Where do you put nails on shingles?

Use 4 nails per shingle placed 6-1/8″ above the butt edge, 1″ and 13″ in from each end and 1/2″ above each cutout. Drive nails straight so that nail head is flush with, but not cutting into shingle surface.

INTERESTING:  Your question: What kind of roofs can be seen in areas of heavy snowfall and why?

Can I nail down loose shingles?

Be sure to nail back down any undamaged shingles that had to be loosened to release damaged shingles. Seal each nail head with a bit of roofing cement.

Why is hand nailing shingles better?

Hand driving nails into shingles allows for the roofer to place the nail on the proper nail line and then drive the nail in. Ensuring that the nails are properly placed each and every time because the head of the hammer stops flush on top of the shingles.

Do shingles need to be glued down?

Asphalt shingles come in two materials: fiberglass and organic. The way each of the shingles is made allows them to resist damage from the sun and from water. … This repair is very simple—all it requires is gluing the shingle back to the roof.

How do you prep a roof for shingles?

Roof Preparation Before Installing Roof Shingles

  1. Secure the roof boards. If you are using the same roof boards without replacing them you really should check each and every one to make sure none of them need replacing. …
  2. Installing the drip edge. …
  3. Ice and water shield. …
  4. Adding the layer of felt.

How long should your nails be for shingles?

Proper Nail Application For Asphalt Shingles

Nails should have a minimum, nominal shank diameter of 11- or 12-gauge, and a minimum head diameter of three-eighths of an inch. The length of each nail must be a minimum of 1¼ inches long, and for roof-overs, Atlas recommends a nail length of at least 2 inches.

INTERESTING:  Quick Answer: What is the only building in London allowed to have a thatched roof?

What size nails do you use for shingles?

If you’re using typical architectural shingles and 3/8-inch-thick sheathing, you’ll need 1‐inch nails. If your building codes require thicker sheathing, you’ll need 1 ¼-inch nails. When installing thicker shingles, you may need to use a longer nail in order to penetrate the OSB beneath fully.